BOSCH DISHWASHER CYCLE TIMES FREE

If you can't succeed in repairing it, the whole module is typically available for about $150 If the heater comes on and the wash cycle is back to normal times (about 90 minutes) then you have fixed it. Put it back together in the reverse order you took it apart. Then get out the soldering iron and resolder the joint. It will look something like this:Д¬lean the joint with an x-acto knife or whatever else you can use. Once it is visible, look for a burned solder joint near the middle of the board as shown in the photos. Once those clips are open, you can pull the circuit board up to see the back side. You can use your fingers to release them. These are similar to the first set, but smaller. Swing the top up so you can get to the next set of clips which hold the circuit board in position. Do not bend too far or you risk breaking off the clip. Unclip by sliding a flat screwdriver or other tool under.

BOSCH DISHWASHER CYCLE TIMES FREE

There are plastic clips at both sides that need to be opened and then the module rotates free with a hinge at the upper side: The next step is to unclip the control module. It is possible to skip disconnecting the wires, but it requires juggling a half-open door and a wobbly control panel while you try to unclip the control module. When these are disconnected, you can remove the panel entirely and set it on a soft surface. Then the connectors to the Power Switch and the Ground Wire: First the connectors to the control module: Once this is done, disconnect the wires holding it in place. Once the screws are removed, the control panel can be pulled up and forward to free it from the door. I also remove the two screws at the top of the front panel to make it easier to get the control panel in and out. Remove the two screws from the side which hold the control panel in place. Open the door and remove the screws from along the top edge of the door. To do this you use a torx #20 screwdriver. Step 2 is to remove the Fascia - the front part of the dishwasher with the buttons on it. Even though the wires to the power switch are insulated, it is always a good idea to make sure there is no power going to the dishwasher. The circuit board should be checked before replacing the heating element because it is faster and easier to check and repair. It is pretty simple to fix if you have a soldering iron and a torx screwdriver (#20 size). One of the common problems with this dishwasher is that the solder joint for the heating circuit can burn out. When this shows it can be a problem with the heating element or the electronics.

Mine showed WASH so there was a heating fault. If the CLEAN light shows, that indicates a NTC (Temperature Sensor) fault. If the RINSE/DRY light shows, that indicates a filling fault If the WASH light shows, that indicates a heating fault To do this press the Power Scrub and Regular Wash buttons at the same time, then press the power button. The first step was running the built-in diagnostics. When the door opened the inside was not warm. Here is how I fixed it:ДЇirst, the symptoms: The dishwasher would run for a long time.

Bosch dishwasher cycle times